Previously sold as a DIY kit valued at $15, the instructions and accompanying video are now free for you to enjoy.
- ball point pen or fine tipped sharpie
- craft knife
- tucking tool
- glue stick
- craft glue
- cigarette lighter (optional)
- smooth foam egg
- fabric in 2 colors and/or motifs (20cm x 14cm each)
- quilt batting (28cm x 12cm)
- 6mm wide ribbon (50cm)
- cord trim (80cm)
- two pearl topped pins
- two large sequins
Cutting Patterns PDF
Print out the PDF at the link below.
Simple Stripes Egg Pattern
Best printed on A4 size paper.
Drawing Lines on your foam egg.
- Your foam egg should have a line that was made during the manufacturing process that runs up each side of the egg from bottom to top. Bottom being the widest part of the egg and top being the narrowest.
- Using your measuring tape as a strait edge, trace the factory marked line with your pen on both sides of the egg.
- Now take your measuring tape and find the place near the top where there is 8cm between each of the lines you just drew.
- Draw a dot at 2cm, 4cm and 6cm. I’ll call these dots the mid-points in the next step.
You can repeat this step from the bottom of your egg if you wish
- Next, using your measuring tape as a straight edge, draw a line connecting the top, one of your mid-points and bottom of the egg.
Do this for all mid-points marked. When finished your egg should have 8 vertical lines.
Here’s what it looks like from the top.
Here’s what it looks like from the bottom.
Please be aware that these measurements are for eggs that are about 7cm tall. You will need to adjust your measurements for eggs of a different size.
Here is the accompanying video. It starts after the lines have already been drawn on the egg.
It’s several years old and so the video quality isn’t that great. But it’s still helpful to watch.
- Cut out batting and fabric panels.
- Cut along all lines on foam egg about 8mm deep.
- Glue on batting and tuck in fabric.
- Glue cord onto seams.
- Pin the bow, hanging ribbon, sequin to the top of the egg.
- Pin the remaining pin and sequin to the bottom of the egg. Dip the end of the pin in craft glue for a secure hold.
a) Cut out 8 panels of quilt batting using the batting pattern provided.
b) Cut out fabric panels using the fabric pattern provided. 4 panels of each color.
a) Glue a panel of batting on the foam in any of the 8 sections. Trim the batting if needed.
b) Next take a fabric panel and place it over the batting. Tuck the edges of the fabric into the foam. Trim fabric as needed.
c) Repeat step a and step b above on the next section with the other color fabric.
d) Alternate panels of the 2 colors of fabric all the way around the egg.
a) Start at the top (small end) off the egg. Using your tucking tool or a large needle, scrape off a small bit of glue from your glue stick and apply it to a vertical seam, where you tucked in the fabric.
b) Next place the cord on top of the glue and pat with your finger to secure. Use your tucking tool or a needle to remove any excess glue.
It is only necessary to use a very small amount of glue.
Do not cut the cord at the bottom of the egg. Continue around the entire egg until you reach the top again.
When finished with a seam, you can either cut the cord and tuck the end into the top of the egg or you can continue on to the next seam without cutting the cord, like I do in the video.
a) Cut 16 cm of ribbon for the hanging ribbon.
Melt the ends with your lighter to prevent fraying.
b) Thread a large sequin onto a pearl headed pin first, then the hanging ribbon.
c) Use the remaining ribbon to make the bow. Make 4 loops.
Adjust the loop size as you like and trim the extra ribbon.
When pinning the ribbon for your bow, use a figure 8 motion and be sure that the shiny side of the ribbon is always pointing outward.
d) Dip the end of the pin in craft glue and pin to the top of the egg.
If you need more help with the bow please see my All About Bows page.
Every effort has been made to provide accurate instructions for this ornament. If you have any questions or feedback please leave a comment below.
If you liked this then you will Love my DIY ornament kits. Please visit My Shop and browse my growing selection of affordable DIY kits.